CD4047B CD4047BE CD4047 CMOS Low-Power Monostable/Astable Multivibrator DIP14

Description

CD4047B CMOS Low-Power Monostable/Astable Multivibrator DIP14
Description
CD4047 consists of a gatable astable multivibrator with logic techniques incorporated to permit positive or negative edge-triggered monostable multivibrator action with retriggering and external counting options.
Inputs include +TRIGGER, -TRIGGER, ASTABLE, ASTABLE/, RETRIGGER, and EXTERNAL RESET. Buffered outputs are Q/, Q and OSCILLATOR. In all modes of operation, and external capacitor must be connected between C-Timing and RC-Common terminal, and an resistor must be connected between the R-Timing and RC-Common terminals.
Astable operation enabled by a high level on the STABLE input or a low level on the ASTABLE/ input, or both. The period of the square wave at the Q and Q/ Outputs in this mode off operation is a function of the external components employed. "True" input pulses on the ASTABLE input or "Complement" pulses on the ASTABLE/ input allow the circuit to be used as a gatable multivibrator. The OSCILLATOR output period will be half of the Q terminal output in the astable mode.
The CD4047B triggers in the monostable mode when a positive-going edge occurs on the +TRIGGER-input while the -TRIGGER is held low. INput pulses may be of any duration relative to the output pulse.
If retrigger capability is desired, the RETRIGGER input is pulsed. The retriggerable mode of operation is limited to positive-going edge. The CD4047B will retrigger as long as the RETRIGGER-input is high, with or without transitions.
An external countdown option can be implemented by coupling "Q"; to an external "N" counter and resetting the counter with the trigger pulse. The counter output pulse is fed back to the ASTABLE/ input and has a duration equal to N times the period of the multivibrator. A high on the EXTERNAL RESET input assures no output pulse during an "ON"; power condition. This input can also be activated to terminate the output pulse at any time.
Features
Lower power consumption: special CMOS oscillator configuration
Monostable (one-shot) or astable (free-running) operation
True and complemented buffered outputs
Only one external R and C required
Buffered inputs
100% tested for quiescent current at 20 V
Standardized, symmetrical output characteristics
5-V, 10-V, and 15-V parametric ratings
Meets all requirements of JEDEC Tentative Standard No. 13B, "Standard Specifications for Description of 'B' Series CMOS Devices"
Monostable Multivibrator Features:
Positive-or negative-edge trigger
Output pulse width independent of trigger pulse duration
Retriggerable option for pulse width expansion
Internal power-on reset circuit
Long pulse widths possible using small RC components by means of external counter provision
Fast recovery time essentially independent of pulse width
Pulse-width accuracy maintained at duty cycles approaching 100%
Astable Multivibrator Features:
Free-running or gatable operating modes
50% duty cycle
Oscillator output available
Good astable frequency stability:
Frequency deviation:
= ±2% + 0.03%/°C @ 100 kHz
= ±0.5% +0.015%/°C @ 10 kHz (circuits "trimmed" to frequency V
DD
= 10 V ± 10%)
Applications:
Digital equipment where low-power dissipation and/or high noise immunity are primary design requirements:
Envelope detection
Frequency multiplication
Frequency division
Frequency discriminators
Timing circuits
Time-delay applications
TERMS OF SALE
We welcome FPO/APO/Military Orders.
APO/FPO ships at domestic rates.
New Bidders, International bidders welcome - we are flexible on customs declarations.
Any questions eoi at lunaticlabs.biz
WINDHAGBATS